Dish LCD30-500 User's Guide download pdf (Page 34)

Chapter 4

Page 30

Installation and Setup

Connect the Speaker Cables

Connect the speaker cables from the monitor to the speakers. Make sure

that the black cylinders on the cables are closer to the monitor connection

than the speaker connection as shown on page 28. Make sure each speaker

wire is connected to the same color on both ends - red to red, black to black.

Note: If speaker wire clips are included on the back of the monitor, you may

place the speaker wires through the clips for a cleaner looking installation.

Plug In Your Monitor to a Power Outlet

Connect the power supply’s DC power cable to the monitor by plugging the

special round connector to the Media Box’s

POWER IN connector on the back.

The notch on the round connector when properly positioned will face you.

Plug the other provided power cable into the power supply, and connect the

power supply plug to a power strip.

Installing the Media Box Stand

The DISH Network LCD monitor is shipped with a stand to hold the Media

Box upright. Complete the following instructions to mount the Media Box

on the stand.

1. Turn off and unplug the monitor.

2. Disconnect all of the cables from the Media Box.

3. Remove the Media Box by pressing down and holding the locking clip

at the bottom of the Media Box while gently pulling the Media Box up

and then away from the monitor.

4. Turn the Media Box so that the DISH Network logo is right side up.

5. Place the stand on the right side of the Media Box.

6. Align the holes on the stand with the holes on the Media Box.

7. Insert and tighten the two screws included with the monitor.

8. Reconnect all of the cables as described in Connecting Your HDTV

Monitor starting on page 28.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 48 49

No comments

Dish LCD30-500 User's Guide Page 34