Dish LCD30-500 User's Guide download pdf (Page 35)

Page 31

Removing the Speakers

The DISH Network LCD monitor is shipped with its speakers attached. If

you want to detach the speakers, follow these instructions.

Note: Make sure the monitor’s power is disconnected before attaching or

detaching speaker connections.

1. Turn off the monitor, and unplug it from power.

2. Detach both speaker cables from both the speaker and the monitor.

3. On each speaker, there are two plastic covers. Squeeze them on the top

and bottom and carefully pull them off.

4. Behind each cover are four Phillips-head screws. Unscrew them.

Note: As you unscrew the speakers, make sure to hold the speaker to

prevent it from being damaged in a fall.

5. Store the screws, covers, and speakers.

Restoring Your Remote Control’s Factory Settings

for Monitor Control

Your remote control provided with your DISH DVI-equipped DISH

Network satellite receiver comes from the factory ready to work with your

DISH Network HDTV monitor. However, the TV mode button can be

programmed to operate other TVs (refer to your DISH Network satellite

receiver User’s Guide for more details). If the remote control has been

programmed to operate a different TV, you can restore the remote control

factory settings to control your DISH Network HDTV monitor by

performing the following:

1. Press and hold the TV button until all four mode buttons light.

Release the button.

2. Use the NUMBER PAD buttons to enter 7-4-2.

3. Press the POUND (#) button. If you entered the

code correctly, the TV mode button will flash three times.

4. Press the SAT button and the monitor should turn on. If it doesn’t

turn on, repeat steps 1 through 4.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 48 49

No comments

Dish LCD30-500 User's Guide Page 35