Dish DISH 500 / DISH 1000 User Manual download pdf (Page 7)

Set skew. To access the skew bolts, loosen the elevation bolts and elevation rod nuts. Loosen

the skew bolts. Set the skew by rotating the elevation and skew bracket to align the mark with the

required angle on the skew scale that you entered on page 4 (see Figure 2). Tighten the skew bolts

securelytokeepthereectorfromrotating.SeeTable1onpage9fortherequiredtorquevalues.

Note: Aftertheskewisset,donottrytone-tunetheskewanglewhenaimingthereector.

Figure 2. Skew Plate

Set elevation. Set the elevation by loosening the elevation bolts and elevation rod nuts. Tilt the

elevation and skew bracket to align the edge of the azimuth plate with the required angle on the

elevation scale. Tighten both nuts on the elevation rod to hold the elevation, but do not tighten the

elevation bolts at this time (see Figure 3).

Figure 3. Setting the Rough Elevation Angle

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Dish DISH 500 / DISH 1000 User Manual Page 7