Dish 612C User's Guide download pdf (Page 81)

Remote Controls

Improving Receiver Control

Checking the Remote Control Address

1 Press and hold the SAT mode button a few seconds until all of the mode buttons light up,

then release SAT.

2 Press POUND (#) twice. The SAT mode button will flash the same number of times as the

address number (for example, three flashes means address 3).

Confirming Remote Control Operation

1 Make sure the remote control has fresh batteries installed and is in SAT mode.

2 Press the SYSTEM INFO button on the receiver’s front panel to display the System

Information screen on the TV.

3 Press and release the RECORD button on the remote control.

4 The Remote Address on the System Information screen changes to match the address

preset in your remote control. Typically, the remote control for the TV is IR only, unless you

have purchased and received an IR/UHF-Pro remote control replacement kit.

5 Select Done to close the System Information screen.

6 Press the POWER button on the remote control to turn the receiver on or off (standby).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 154 155

No comments

Dish 612C User's Guide Page 81