Dish 6.3 User's Guide download pdf (Page 22)

4 Press POUND (#). If you entered the address correctly, SAT will

flash three times. Write down the number you entered in the space

provided on the inside back cover.

5 Press RECORD. Make sure the Remote Address you see on

the System Information screen is the same as the one you

entered in step 3. If it isn't, the remote cannot control the receiver.

Press RECORD a second time.

6 Select Done to close the System Information screen.

CHANGING THE UHF FREQUENCY USING THE A/B

WITCH (DISH PLAYER-DVR 942, VIP222, VIP622

DVR,

AND VIP722 DVR ONLY)

Your remote has a switch to change the UHF frequency that your

remote control uses. It comes preset to the A position but you can

change the setting to the B position to lessen the likelihood of any other

UHF remote interfering with yours.

1 Remove the battery cover from the remote control.

2 Use a small screw driver or a paper clip to carefully

change the setting.

3 Put the battery cover back on the remote control.

4 Use the SYS INFO button on the front panel to

open the System Information screen.

5 Press RECORD on the remote control.

6 Make sure the remote address on the System

Information screen shows the correct band

information:

• Switch Position A—IR/UHF Pro Band A

• Switch Position B—IR/UHF Pro Band B

All receiver models (except the DISH Player-DVR

942, ViP222, ViP622 DVR, and ViP722 DVR)

must use switch position A or the remote will not

control the receiver.

Battery

6.3 Main Text.fm Page 10 Friday, February 15, 2008 10:17 AM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 38 39

No comments

Dish 6.3 User's Guide Page 22